|
|
ASPE Seeks Public Comment on Proposed Hot Water Temperature Control Standard
The American Society of Plumbing Engineers (ASPE) is opening for public comment the proposed ASPE Plumbing Engineering & Design Technical Standard 15: Hot Water Temperature and Control. Public comments will be accepted until noon CST on December 30, 2011. The draft standard and public comment form can be accessed at aspe.org/PublicReview.
The intent of ASPE 15 is to provide minimum requirements to regulate hot water temperature and pressure disturbances within the piping system in a plumbing installation to protect public health, safety, and welfare. It is to be a mandatory regulation applicable to all new and renovated plumbing installations. This standard is not intended to apply to existing installations.
“ASPE 15 will provide a central source for acceptable ranges of hot water temperatures at the point of discharge and acceptable means of control to remove confusion over acceptable delivery temperatures,” says David E. Dexter, FASPE, chair of ASPE’s Design Standards Committee. “Establishing acceptable hot water delivery temperatures in a single document decreases the potential risk of injury or harm to the end user.”
For more information about ASPE’s standards development process, visit aspe.org/Standards or contact Gretchen Pienta at gpienta@aspe.org.
About ASPE
ASPE is the only professional organization devoted to the training and certification of plumbing engineers and designers. ASPE and its 6,200 worldwide members are dedicated to protecting the health, welfare, and safety of the public through the dissemination of technical data and information to expand the base of knowledge among plumbing engineers, designers, contractors, code officials, inspectors, and manufacturers. For more information, visit ASPE.org
|
